Custom Made Trim
MISC | Caps & Bases | Corners | Eave & Rake Trim
Flashings | Ridges | Soffits | Track Covers
MISC |
Outside Closure
1"x36" Foam Closure
|
Inside Closure
1"x36" Foam Closure
|
Vented Closure
1"x36" Foam Closure
|
Mastic Tape
|
|
|
Flashers
Size |
Outside Pipe
Diameter |
1 |
1/4"-2" |
2 |
1 3/4"-3 1/4" |
3 |
1/4"-5" |
4 |
3"-6 1/4" |
1. Cut to pipe diameter marked on Flashers®. This is approximately 20% smaller than the diameter of the pipe. |
2. Slide the Flashers® down the pipe, using water to lubricate if necessary.
|
3
. Form and bend the aluminum base of the Flashers® to fit the surface of the roof.
|
4
. Seal the Flashers® by applying urethane/silicone sealant between the flasher and the roof. Use a large slot screwdriver to press the base down tightly. |
5
. Fasten the Flashers® with water-resistant fasteners
to complete the seal. |
Back to Top
|
|
Drip Cap - Part #12 |
|
Z-Strip - Part #18 |
|
J-Channel - Part #3 |
|
Wide Z-Strip -
Part #26 |
|
Rat Guard - Part #38 |
|
Rat Guard w/Screw
Flange - Part #48
|
|
Base Molding -
Part #25 |
|
F-J Channel -
Part #23 |
Back to Top
|
|
Outside Corner -
Part #4 |
|
Inside Corner -
Part #5 |
|
2.5"x2.5" Angle -
Part #34 |
Back to Top
| |
|
Eave - Part #21 |
|
Fascia - Part #29 |
|
Gable Trim 1 - Part #11 |
|
Gable Trim 2 - Part #10 |
|
Rake Trim - Part #16 |
|
Drip Edge - Part #56 |
Back to Top
|
|
Universal Sidewall - Part #7 |
|
Universal Endwall - Part #8 |
|
Pitch Break/Denver Endwall - Part #14 |
|
W-Valley - Part #15 |
|
Gambrel Flashing - Part #58 |
Back to Top
|
|
Standard Ridge -
Part #1 |
|
Flat Ridge - Part #2 |
|
High Ridge - Part #40 |
Back to Top
|
|
24" Soffit - Part #64 |
|
Plain Soffit - Part #49 |
|
Soffit - Part #42 |
Back to Top
|
|
Cannonball Track Cover - Part #43 |
|
National Track Cover - Part #47 |
|
Top Mount Track Cover - Part #36 |
Back to Top
|
Print This Page